Airflow Inspection
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the purge solenoid valve. See PURGE SOLENOID VALVE INSPECTION [L5] .
- Inspect airflow between the ports under the following conditions.
- If not as specified, replace the purge solenoid valve. See PURGE SOLENOID VALVE REMOVAL/INSTALLATION [L5] .
CONTINUITY CHART
| Measured condition | Continuity between A-B |
|---|---|
| When voltage is not applied between terminals A and B | No airflow |
| When voltage is applied between terminals A and B | Airflow detected |