Using M-MDS
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the M-MDS to the DLC-2.
- Switch the ignition to ON.
- Using the simulation function "FP", start the fuel pump. See ON-BOARD DIAGNOSTIC TEST [L5] .
- Verify that there is no fuel leakage from the pressurized parts.
- If there is leakage, replace the fuel hoses and clips.
- If there is damage on the seal on the fuel pipe side, replace the fuel pipe.
Standard
There shall be no leakage after 5 min.
- After reinstallation, repeat step 3-4 in the fuel leakage inspection.