Cooling Fan Component Removal Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Remove the lower radiator hose clip from the radiator cowling.
Remove the lower radiator hose stay

Fig 1: Identifying Lower Radiator Hose Clip From Radiator Cowling
Courtesy of MAZDA MOTORS CORP.
Remove the ATF oil cooler pipes from the clips installed to the underside of the radiator cowling. (ATX)

Fig 2: View Of ATF Oil Cooler Pipes From Clips
Courtesy of MAZDA MOTORS CORP.
Release the left and right tabs on the upper side of the radiator by pressing them in the direction shown in the figure

Fig 3: Locating Left/Right Tabs On Upper Side Of Radiator
Courtesy of MAZDA MOTORS CORP.
Lift the cooling fan component to remove it from the left and right insertion areas on the lower side of the radiator.

Fig 4: Locating Left/Right Insertion Areas On Lower Side Of Radiator
Courtesy of MAZDA MOTORS CORP.
Remove the cooling fan component from above the engine compartment.

Fig 5: Identifying Cooling Fan Component In Engine Compartment
Courtesy of MAZDA MOTORS CORP.