Engine Oil Replacement [L5]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work around or under a lifted vehicle if it is not securely supported on safety stands.
Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.

CAUTION:

If engine oil is spilled on the exhaust system, wipe it off completely. If you fail to wipe the spilled engine oil, it will produce fumes because of the heat.
Parts for engines manufactured in Mexico and Hiroshima cannot be used interchangeably as the engine will not operate correctly resulting in a serious malfunction. To prevent this, when replacing parts refer to the VEHICLE IDENTIFICATION NUMBER (VIN) CODE ' table below and verify the engine's place of manufacture before performing the servicing. See VEHICLE IDENTIFICATION NUMBER (VIN) CODE )

Position the vehicle on level ground.
Remove the oil filler cap.
Remove the oil pan drain plug.
Dram the engine oil into a container.
Install the oil pan drain plug.
- With washer
  1. Install the oil pan drain plug with a new washer.
Tightening torque

30-41 N.m {3.1-4.1 kgf.m, 23-30 ft.lbf}
- Without washer
  1. Inspect the seal rubber of the oil pan drain plug and make sure there are no cracks or damage.
    - If necessary, replace the oil pan drain plug
  2. Clean the flange surface (seal rubber) on the oil pan drain plug, then install the oil pan drain plug.
Tightening torque

25-30 N.m {2.6-3.0 kgf.m, 19-22 ft.lbf}
NOTE:
- The amount of residual oil in the engine can vary according to factors such as the replacement method and oil temperature. Verify the oil level after engine oil replacement.

Refill with the following type and amount of the engine oil.

Engine oil specification

ENGINE OIL SPECIFICATION CHART

Item	U.S.A. and CANADA	Except U.S.A. and CANADA
Engine oil grade	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.
Engine oil viscosity	5W-20	5W-20 - If SAE 5W-20 engine oil is not available in your market, use SAE 5W-30 engine oil.

Engine oil capacity (approx. quantity)

Oil replacement: 4.6 L {4.9 US qt, 4.0 Imp qt}

Oil and oil filter replacement: 5.0 L {5.3 US qt, 4.4 Imp qt}

Total (dry engine): 5.5 L {5.8 US qt, 4.8 Imp qt}

Install the oil filler cap.
Start the engine and confirm that there is no oil leakage.
- If there is oil leakage, repair or replace the applicable part.
Inspect the oil level. See ENGINE OIL LEVEL INSPECTION [L5] .