Continuity Inspection
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION [G66M-R] .)
- Inspect for continuity between the neutral switch terminals using an ohmmeter.
- If not as specified, replace the neutral switch. (See
NEUTRAL SWITCH REMOVAL/INSTALLATION [G66M-R]
.)SPECIFICATION
Measured condition Continuity Rod pushed Continuity detected Except above No continuity
- If not as specified, replace the neutral switch. (See
NEUTRAL SWITCH REMOVAL/INSTALLATION [G66M-R]
.)