LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 550 (Engine Control System (L5)) >> Knock Sensor (KS) Removal/Installation [L5]

Knock Sensor (KS) Removal/Installation [L5]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION [L5] .)
  3. Remove the intake manifold. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L5] .)
  4. Disconnect the KS connector.
  5. Remove the KS.
  6. Install in the reverse order of removal.
    Fig 1: Lnock Sensor & Bolt With Torque Specifications
    G06205261Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals