Continuity Inspection

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Verify that the CPP switch is installed properly.
Disconnect the negative battery cable.
Disconnect CPP switch connector. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)

Inspect for continuity between the CPP switch terminals using an ohmmeter.

If not as specified, replace the CPP switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)

Fig 1: Identifying CPP Switch & Connector Terminals

Courtesy of MAZDA MOTORS CORP.

SPECIFICATION

Measured condition	Clutch pedal position	Continuity
Rod pushed	Clutch pedal released	Continuity detected
Except above	Clutch pedal depressed	No continuity