LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 549 (Engine Mechanical [Service Information L5]) >> Timing Chain Removal/Installation [L5] >> No. 3 Engine Mount Removal Note

No. 3 Engine Mount Removal Note

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L5] .)
  2. Install the SST  using the following procedure.
    CAUTION:
    • Refer to the SST instruction manual for the basic handing procedure.
      Fig 1: Identifying SST Components
      G06199792Courtesy of MAZDA MOTORS CORP.
    1. As shown in the figure, set the rear shafts of the SST  to the left and right shock absorber bolts.
      Fig 2: Setting Rear Shafts Of SST
      G06199793Courtesy of MAZDA MOTORS CORP.
    2. Install front foot No. 2 to the left/right front shaft of the SST  , then align the groove of the front shaft of the SST  with the folded up part of the vehicle as shown in the figure.
      3. Fig 3: Aligning Groove Of SST With Vehicle
      G06199794Courtesy of MAZDA MOTORS CORP.
    3. Adjust the positions of the SST side bars so that they are the same height (left and right) and horizontal.
    4. Make sure each joint is securely tightened.
  3. Support the engine using the SST  .
    Fig 4: Supporting Engine Using SST
    G06199795Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals