No. 8 Engine Runs Rough/Rolling Idle [L5]: Notes
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
| 8 |
ENGINE RUNS ROUGH/ROLLING IDLE |
| DESCRIPTION |
- Engine speed fluctuates between specified idle speed and lower speed, and engine shakes excessively
- Idle speed is too slow and engine shakes excessively
|
| POSSIBLE CAUSE |
- Air leakage from intake air system parts
- A/C system operation is improper
- Erratic signal to ignition coil
- Spark plug malfunction
- Purge solenoid valve malfunction
- Erratic signal from PSP switch
- Improper operation of electronic throttle control system
- Idle learning of electronic throttle control system is not completed
- EGR valve malfunction
- Erratic or no signal from CMP sensor
- Low engine compression
- Improper valve timing
- Improper variable valve timing control system operation
- Erratic signal from CKP sensor
- Improper air/fuel mixture ratio control operation (abnormal signal form MAF sensor, A/F senor or HO2S)
- Open or short circuit in PCM ground circuit
- Poor fuel quality
- PCV valve malfunction
- Air cleaner restriction
- Restriction in exhaust system
- Disconnected electrical connectors
- Inadequate fuel pressure
- Fuel pump body mechanical malfunction
- Improper load signal input
- Fuel line restriction or clogging
- Improper fuel injection control operation
- Fuel leakage from fuel injector
- Fuel injector clogging
- Engine overheating
- Vacuum leakage
- Pressure regulator malfunction (built-in fuel pump unit)
WARNING:
The following troubleshooting flow chart contains fuel system diagnosis and repair procedures. Read the following warnings before servicing the fuel system:
CAUTION:
- Disconnecting/connecting the quick release connector without cleaning it may cause damage to the fuel pipe and the quick release connector. Always clean the quick release connector joint area before disconnecting/connecting, and make sure that it is free of foreign material.
|