LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (Lighting System) >> Headlight Bulb Removal/Installation >> High-beam

Headlight Bulb Removal/Installation: High-beam

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable
  2. Open the hood.
  3. Remove the bolts shown in the figure and set the coolant reserve tank out of the way. (RH only)
    Fig 1: Coolant Reserve Tank Bolts With Torque Specifications
    G06201018Courtesy of MAZDA MOTORS CORP.
  4. Disconnect the connector.
    Fig 2: Disconnecting Connector
    G06201036Courtesy of MAZDA MOTORS CORP.
  5. Rotate the headlight bulb in the direction of the arrow shown in the figure.
    6. Fig 3: Rotating Headlight Bulb
    G06201037Courtesy of MAZDA MOTORS CORP.
  6. Remove the headlight bulb.
    CAUTION:
    • A halogen bulb generates extremely high heat when it is illuminated. If the surface of the bulb is soiled, excessive heat will build up and the life of the bulb will be shortened. When replacing the bulb, hold the metal flange, not the glass.
  7. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals