Schedule 2 (Unique Driving Conditions) for Mexico

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Repeated short-distance driving
Driving in dusty conditions
Driving with extended use of brakes
Driving in areas where salt or other corrosive materials are used
Driving on rough or muddy roads
Extended periods of idling or low-speed operation
Driving for long periods in cold temperatures or extremely humid climates
Driving in extremely hot conditions
Driving in mountainous conditions continually

Maintenance Interval	Number of months or kilometers, whichever comes first
	Months	3	6	9	12	15	18	21	24	27	30	33	36
	x1000 km	5	10	15	20	25	30	35	40	45	50	55	60
ENGINE
Engine valve clearance (for L5 engine)		Audibly inspect every 120,000 km, if noisy, adjust
Drive belts	L5 engine								I
Drive belts	MZI-3 7 engine	Inspect every 40,000 km or 2 years Replace every 240,000 km
Engine oil		R	R	R	R	R	R	R	R	R	R	R	R
Engine oil filter		R	R	R	R	R	R	R	R	R	R	R	R
COOLING SYSTEM
Cooling system									I
Engine coolant	FL22 type ^*1	Replace at first 190,000 km or 10 years; after that, every 60,000 km or 3 years
Engine coolant	Others								R
Engine coolant level		I	I	I	I	I	I	I	I	I	I	I	I
FUEL SYSTEM
Air cleaner element			C		R		C		R		C		R
Fuel lines and hoses									I^*2
Hoses and tubes for emission									I^*2
Fuel filter									R
IGNITION SYSTEM
Spark plugs		Replace every 60,000 km
ELECTRICAL SYSTEM
Function of all lights		I	I	I	I	I	I	I	I	I	I	I	I
CHASSIS and BODY
Brake lines, hoses and connections					I				I				I
Brake fluid level			I		I		I				I		I
Brake fluid									R
Disc brakes			I		I		I		I		I		I
Tire (Rotation)		Rotate every 10,000 km
Tire inflation pressure and tire wear			I		I		I		I		I		I
Steering operation and linkages			I		I		I		I		I		I
Power steering fluid level			I		I		I		I		I		I
Front and rear suspension, ball joints and wheel bearing axial play					I				I				I
Drive shaft dust boots					I				I				I
Bolts and nuts on chassis and body					T				T				T
Exhaust system and heat shields					I				I				I
All locks and hinges			L		L		L		L		L		L
Washer fluid level			I		I		I		I		I		I
AIR CONDITIONER SYSTEM
Cabin air filter					R				R				R
ENGINE
Engine valve clearance (for L5 engine)		Audibly inspect every 120,000 km, if noisy, adjust
Drive belts	L5 engine				I								I
Drive belts	MZI-3 7 engine	Inspect every 40,000 km or 2 years Replace every 240,000 km
Engine oil		R	R	R	R	R	R	R	R	R	R	R	R
Engine oil filter		R	R	R	R	R	R	R	R	R	R	R	R
COOLING SYSTEM
Cooling system					I								I
Engine coolant	FL22 type ^*1	Replace at first 190,000 km or 10 years; after that, every 60,000 km or 3 years
Engine coolant	Others				R								R
Engine coolant level		I	I	I	I	I	I	I	I	I	I	I	I
FUEL SYSTEM
Air cleaner element			C		R		C		R		C		R
Fuel lines and hoses					I^*2								I
Hoses and tubes for emission					I^*2								I
Fuel filter					R								R
IGNITION SYSTEM
Spark plugs		Replace every 60,000 km
ELECTRICAL SYSTEM
Function of all lights		I	I	I	I	I	I	I	I	I	I	I	I
CHASSIS and BODY
Brake lines, hoses and connections					I				I				I
Brake fluid level			I				I		I		I
Brake fluid					R								R
Disc brakes			I		I		I		I		I		I
Tire (Rotation)		Rotate every 10,000 km
Tire inflation pressure and tire wear			I		I		I		I		I		I
Steering operation and linkages			I		I		I		I		I		I
Power steering fluid level			I		I		I		I		I		I
Front and rear suspension, ball joints and wheel bearing axial play					I				I				I
Drive shaft dust boots					I				I				I
Bolts and nuts on chassis and body					T				T				T
Exhaust system and heat shields					I				I				I
All locks and hinges			L		L		L		L		L		L
Washer fluid level			I		I		I		I		I		I
AIR CONDITIONER SYSTEM
Cabin air filter					R				R				R

Chart symbols:

I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary.

R: Replace

C: Clean

L: Lubricate

T: Tighten

Remarks

After the prescribed period, continue to follow the described maintenance at the recommended intervals.
Refer below for a description of items marked* in the maintenance chart.
*1: Use FL22 type coolant in vehicles with the inscription "FL22" on the radiator cap itself or the surrounding area. Use FL22 when replacing the coolant.

*2: According to state/provincial and federal regulations, failure to perform maintenance on these items will not void your emissions warranties. However, Mazda recommends that all maintenance services be performed at the recommended time or kilometer period to ensure long-term reliability.