Wiring Harness: Overview

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver.

Fig 1: Removing Wiring Harness

Courtesy of MAZDA MOTORS CORP.

CAUTION:

Do not remove the harness protective tape. Otherwise, the wires could rub against the body, which could result in water penetration and electrical shorting.

Fig 2: Precaution For Wiring Harness Protective Tape

Courtesy of MAZDA MOTORS CORP.