Fuel Injector: Testing and Inspection

FUEL INJECTOR INSPECTION [MZR 2.5]

Resistance Inspection

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable. Removal and Replacement

3. Remove the plug hole plate. Service and Repair

4. Disconnect the fuel injector connector.

5. Inspect the resistance between fuel injector terminals A and B.






Fuel injector resistance
- 11.4-12.6 ohms [20 °C {68 °F}]

- If not within the specification, replace the fuel injector. Service and Repair