Oil Pressure Sensor Inspection

OIL PRESSURE SENSOR INSPECTION [13B-MSP]

NOTE:
- Before performing the following inspection, make sure to follow the troubleshooting flowchart. Initial Inspection and Diagnostic Overview

1. Turn the ignition switch to ON position.

2. Verify that the voltage at PCM terminals 2R is within the specification.

- If not as verified, replace the oil pressure sensor. Service and Repair

Oil Pressure Sensor Output Voltage
- 0.55-1.03 V [Oil Pressure: 50-150 kPa {0.51-1.52 kgf/cm2, 7.3-21.7 psi}]