Starter Cut Relay: Service and Repair

STARTER CUT RELAY REMOVAL/INSTALLATION [MTX]

Advanced Keyless Entry And Push Button Start System Only

1. Disconnect the negative battery cable.

2. Remove the following parts:

- Front scuff plate (LH) Front Scuff Plate Removal/Installation
- Front side trim (LH) Front Side Trim Removal/Installation
- Side wall Side Wall Removal/Installation
- Console Console Removal/Installation

3. Set the hood release lever out of the way. Service and Repair

4. Remove the lower panel. Lower Panel Removal/Installation

5. Disconnect the connector.






6. Remove the nut.






7. Remove the starter cut relay.

8. Install in the reverse order of removal.