LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Fuel System [MZR 2.5]) >> Fuel Pump Unit Removal/Installation >> Set Plate Removal Note

Set Plate Removal Note

WARNING: This page is about a different variant/trim than selected.
  1. Install the SST  shown in the figure.
  2. Remove the set plate using the SST  .
    Fig 1: Removing Set Plate Using SST
    G07620554Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals