LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Cooling System [MZR 2.5]) >> Radiator Removal/Installation >> Radiator Installation Note

Radiator Installation Note

WARNING: This page is about a different variant/trim than selected.
  1. Align the bracket groove of the condenser to the radiator positioning rib.
    Fig 1: Aligning Bracket Groove Of Condenser To Radiator Positioning Rib
    G07620464Courtesy of MAZDA MOTORS CORP.
  2. Align the bracket notch of the condenser to the radiator positioning rib.
    Fig 2: Aligning Bracket Notch Of Condenser To Radiator Positioning Rib
    G07620464Courtesy of MAZDA MOTORS CORP.
  3. Install the condenser installation bolts as shown in the illustration.
Fig 3: Bolts Secure Condenser To Radiator
G07620463Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals