Throttle Body Removal Note
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Turn off the engine and wait until it is cool. Even then, be very careful when removing the cap. Wrap a thick cloth around it and slowly turn it counterclockwise to the first stop. Step back while the pressure escapes.
- When you are sure all the pressure is gone, press down on the cap using the cloth, turn it, and remove it.
CAUTION:
- Do not plug the water hose with a sharp-edged object. Otherwise, the hose could be damaged.
- Wrap a clean cloth around the cooling system cap and release the pressure by loosening the cap slowly.
- Remove the water hose from the throttle body and plug the water hose quickly.