LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical (Service Information MZR 2.5)) >> Timing Chain Removal/Installation >> Crankshaft Pulley Lock Bolt Removal note

Crankshaft Pulley Lock Bolt Removal note

WARNING: This page is about a different variant/trim than selected.
  1. Rotate the crankshaft in the direction of the engine rotation and remove the cylinder block lower blind plug when the No. 1 cylinder is at the point prior to top dead center (TDC) of compression, then install the SST  .
  2. Rotate the crankshaft in the direction of the engine rotation so that the No. 1 piston is at TDC of the compression stroke. (Until the counterweight contacts SST  and stops.)
    Fig 1: Installing SST
    G06199768Courtesy of MAZDA MOTORS CORP.
  3. Hold the crankshaft pulley by using the SSTs  .
    Fig 2: Holding Crankshaft Pulley Using SST
    G06199791Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals