LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical (Service Information MZR 2.5)) >> Rear Oil Seal Replacement >> Notes

Rear Oil Seal Replacement: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION .) (ATX) (See MANUAL TRANSAXLE REMOVAL/INSTALLATION .) (MTX)
  2. Remove the drive plate (ATX) or the flywheel (MTX). (See DRIVE PLATE REMOVAL/INSTALLATION .) (ATX) (See CLUTCH UNIT REMOVAL/INSTALLATION .) (MTX)
  3. Remove in the order indicated in the table.
  4. Install in the reverse order of removal.
    REAR OIL SEAL INSTALLING REFERENCE CHART

    1 Bolt
    2 Rear oil seal
    (See REAR OIL SEAL INSTALLATION NOTE .)
    Fig 1: Rear Oil Seal Removal Sequence
    G07620412Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals