Spool Valve Operation Inspection

WARNING: This page is about a different variant/trim than selected.

Remove the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION .)
Verify that the spool valve in the OCV is in the maximum valve timing retard position as indicated in the illustration.
- If not as specified, replace the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION .)
Verify that the battery is fully charged. (See BATTERY INSPECTION [MZR 2.5] .)
- If not as specified, recharge the battery. (See BATTERY RECHARGING [MZR 2.5] .)
  
  Fig 1: Spool Valve
  Courtesy of MAZDA MOTORS CORP.
NOTE:
- When applying battery positive voltage between the OCV terminals, the connection can be either of the following:
  - Positive battery cable to terminal A, negative battery cable to terminal B
  - Positive battery cable to terminal B, negative battery cable to terminal A
    
    Fig 2: OCV Connector Terminals
    Courtesy of MAZDA MOTORS CORP.
Apply battery positive voltage between the OCV terminals and verify that the spool valve operates and moves to the maximum valve timing advance position.
- If not as specified, replace the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION .)
Stop applying battery positive voltage and verify that the spool valve returns to the maximum valve timing retard position.
- If not as specified, replace the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION .)
Install the OCV. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION .)

Fig 3: Valve Timing Retard And Advance Position
Courtesy of MAZDA MOTORS CORP.