Engine Mount Installation Note

WARNING: This page is about a different variant/trim than selected.

Install the through bolt A on the front crossmember side until approximately three pitches are showing.
Temporarily tighten bolts B and C.
Tighten the bolts in the order of B and C.
Tightening torque 77-103 N.m {7.9-10 kgf.m, 57-75 ft.lbf}
NOTE:
- If the No. 3 engine mount bracket and the engine are removed, retighten the No. 3 engine mount stud bolts.
  
  Fig 1: Engine Mount Bracket Mounting Bolt
  Courtesy of MAZDA MOTORS CORP.
Tighten the No. 3 engine mount stud bolts.
Tightening torque 7-13 N.m {72-132 kgf.cm, 62-115 in.lbf}

Fig 2: Engine Mount Stud Bolts
Courtesy of MAZDA MOTORS CORP.
Secure the engine and transaxle using an engine jack.
Temporarily tighten the No. 3 engine mount bolt and nuts.

Fig 3: Supporting Engine And Transaxle Using Engine Jack
Courtesy of MAZDA MOTORS CORP.
Tighten the No. 3 engine mount bolt and nuts in the order shown in the illustration.
Tightening torque 75-104 N.m {7.7-10 kgf.m, 56-76 ft.lbf}
Temporarily tighten the No. 4 engine mount bolts.

Fig 4: Engine Mount Bolt And Nuts Tightening Sequence
Courtesy of MAZDA MOTORS CORP.
Tighten the No. 4 engine mount bolts.
Tightening torque 77-103 N.m {7.9-10 kgf.m, 57-75 ft.lbf}

Fig 5: Engine Mount Bolts
Courtesy of MAZDA MOTORS CORP.
Tighten the bolt D.
Tightening torque 77-103 N.m {7.9-10 kgf.m, 57-75 ft.lbf}

Fig 6: Engine Mount Rubber And Bracket
Courtesy of MAZDA MOTORS CORP.
Tighten the bolt A.
Tightening torque 94-116 N.m {9.6-11 kgf.m, 70-85 ft.lbf}

Fig 7: Engine Mount Rubber And Bracket
Courtesy of MAZDA MOTORS CORP.