Inspection method for actuators or relays
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS to the DLC-2.
- Switch the ignition to ON (engine off).NOTE:
- If the engine starts and runs, perform the following steps during idle.
- Prepare the output state control function for actuators or relays that you are inspecting.
- Vibrate the actuator or relay with your finger for 3 s after output state control function is activated.
- If variable click sound is heard, check for poor connection or poorly mounted actuator or both, or the relay.
NOTE:
- Vibrating relays too strongly may result in open relays.