LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Symptom Troubleshooting [Engine Mechanical MZR 2.5]) >> Engine Control System Operation Inspection >> Evaporative Emission (EVAP) System Leak Inspection >> EVAP system leak inspection using the M-MDS >> Evaporative system test procedure

Evaporative system test procedure

WARNING: This page is about a different variant/trim than selected.
  1. Verify that all PIDs within the following specifications.
    NOTE:
    • To successfully perform this procedure, all PIDs must be within the specifications before proceeding to the next step.
  2. Select the following items from the initialization screen of the M-MDS.
    1. Select the "Powertrain".
    2. Select the "Fuel".
    3. Select the "EVAP Test".
    • Verify that ECT and IAT are within the specifications at the confirmation screen. To successfully perform this procedure, ECT and IAT must be within the spec before proceeding to the next step.
    • Fuel Level must be maintained within 15%-85 %  . PCM will cancel the EVAP Test If the Fuel Level is lower than 15 % or higher than 85 %  .
    Fig 1: Display PID Specfications
    G07620310Courtesy of MAZDA MOTORS CORP.
  3. Verify the test results described on the M-MDS and follow the instructions.
scientia non olet · About LEMON Manuals