LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System [MZR 2.5]) >> Barometric Pressure (BARO) Sensor Removal/Installation

Barometric Pressure (BARO) Sensor Removal/Installation

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • The BARO sensor cannot be removed as a single unit. When replacing the BARO sensor, replace it together with the PCM as a single unit.
  1. Remove the PCM. (See PCM REMOVAL/INSTALLATION .)
scientia non olet · About LEMON Manuals