No. 7 No Shifting
WARNING: This page is about a different variant/trim than selected.
DESCRIPTION AND POSSIBLE CAUSE
| 7 |
No shifting |
| DESCRIPTION |
- Single shift position only.
- Sometimes it shifts correctly.
|
| POSSIBLE CAUSE |
- When the gear position is fixed in 3GR due to the fail-safe operation, the malfunction is in the ATX.
- Perform malfunction diagnosis according to No. 6 "Low maximum speed and poor acceleration".
NOTE:
- If a tire of a different diameter from the standard tire is installed, the TCM determines that the driving mode is the AAS mode, and may change to a different shift timing from the normal timing.
- Clutch slippage, burnt
- Line pressure low
- Shift solenoid D malfunction
- Shift solenoid A malfunction
- Shift solenoid B malfunction
- Shift solenoid C malfunction
- Shift solenoid F malfunction
- Pressure control solenoid A malfunction
- Pressure control solenoid B malfunction
- Body GND malfunction
- Control valve body malfunction
- Signal malfunction
- Vehicle speed sensor malfunction
- Sensor GND malfunction
- APP sensor malfunction
- Input/turbine speed sensor malfunction
- MAF sensor malfunction CKP sensor malfunction
- Transaxle fixed in 3GR (Operation of fail-safe function)
- Short or open circuit in wiring harness
- Poor connection of connector
- Disconnected shift solenoid connector
- Poor ground of shift solenoid
- Transaxle fixed in 4GR (Operation of fail-safe function)
- Forward clutch slippage
- Vehicle speed sensor malfunction
- Shift solenoid A malfunction (Stuck on)
- Poor connection of connector
- Transaxle fixed in M position
- M position switch (built-in selector lever component) malfunction
|