LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Symptom Troubleshooting [Automatic Transaxle - FS5A-El]) >> No. 5 No Creep At All >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.
NO. 5 NO CREEP AT ALL (FS5A-EL) DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 INSPECT SELECTOR CABLE ADJUSTMENT FOR MALFUNCTION 
  • Does the vehicle creep in arty position?
Yes Go to the next step.
No Inspect or adjust the selector cable.
(See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
2 INSPECT THROTTLE OPENING SIGNAL FOR MALFUNCTION 
Yes Go to the next step.
No Repair or replace any malfunctioning parts.
3 INSPECT TCM FOR POOR GND 
  • Disconnect the TCM connector.
  • Is the resistance between the ground terminal at the TCM connector and the body ground less than 5.0 ohms?
Yes Go to the next step.
No Repair open ground circuit.
4 INSPECT LINE PRESSURE CONTROL SIGNAL FOR MALFUNCTION 
Yes Go to the next step.
No Repair or replace any malfunctioning parts.
5 VERIFY IF MALFUNCTION CAUSE IS TORQUE CONVERTER OR TRANSAXLE (INCLUDING CONTROL VALVE BODY) 
Yes Overhaul the control valve body and repair or replace any malfunctioning parts.
(See AUTOMATIC TRANSAXLE - [FS5A-EL] -- MAZDA6 ) If any problem remains, overhaul the transaxle and repair or replace any malfunctioning parts.
(See AUTOMATIC TRANSAXLE - [FS5A-EL] -- MAZDA6 )
No Replace the torque converter.
(See AUTOMATIC TRANSAXLE - [FS5A-EL] -- MAZDA6 )
6
  • Verify the test results.
    • If normal, return to the diagnostic index to service any additional symptoms.
    • If the malfunction remains, inspect the related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis.
      • If the vehicle is repaired, troubleshooting is completed.
      • If the vehicle is not repaired or additional diagnostic information is not available, replace the TCM.