No. 22 No Engine Braking In 1GR Position Of M Position: Notes
WARNING: This page is about a different variant/trim than selected.
DESCRIPTION AND POSSIBLE CAUSE
| 22 |
No engine braking in 1GR position of M position |
| DESCRIPTION |
- Engine speed drops to idle but the vehicle coasts when the accelerator pedal is released when in 1GR of M position at low vehicle speed.
|
| POSSIBLE CAUSE |
- Clutch slippage, burnt (low and reverse brake)
- Line pressure low
- Shift solenoid D malfunction
- Shift solenoid E malfunction
- Shift solenoid C malfunction
- Pressure control solenoid B malfunction
- Control valve body malfunction
- Body GND malfunction
- Signal malfunction
- APP sensor malfunction
- VSS malfunction
- Sensor GND malfunction
- Input/turbine speed sensor malfunction
- TCM does not determine that the M position switch is ON (short, or open circuit, poor operation)
- M position switch signal malfunction
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted.
|