No. 2 Vehicle Moves In N Position: Notes
WARNING: This page is about a different variant/trim than selected.
DESCRIPTION AND POSSIBLE CAUSE
| 2 |
Vehicle moves in N position |
| DESCRIPTION |
- Vehicle creeps in N position.
- Vehicle creeps if brake pedal is not depressed in N position.
|
| POSSIBLE CAUSE |
- If the vehicle moves in N position, basically, the malfunction is in the ATX. Since a malfunction in the sensor circuit or output circuit is the cause of the malfunction in the ATX, inspect the sensors, output circuit, and the related wiring harnesses.
- Clutch burnt (Forward clutch)
- Control valve body malfunction
- Selector lever position disparity (Although the selector indicator shows N position, the hydraulic circuit shows D or R position)
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted.
|