Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.

NO. 2 VEHICLE MOVES IN N POSITION (FS5A-EL) DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	INSPECT SELECTOR CABLE ADJUSTMENT FOR MALFUNCTION Does the vehicle creep when the selector lever is moved slightly in N position?	Yes	Go to the next step.
1		No	Adjust the selector cable. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
2	INSPECT TCM FOR POOR GND Disconnect the TCM connector. Is the resistance between the ground terminal at the TCM connector and the body ground less than 5.0 ohms?	Yes	Go to the next step.
2		No	Repair open ground circuit. Reconnect the TCM connector.
3	VERIFY IF MALFUNCTION CAUSE IS LINE PRESSURE CONTROL SIGNAL OR TRANSAXLE (INCLUDING CONTROL VALVE BODY) Inspect the value at the following TCM PID using the M-MDS. (See ON-BOARD DIAGNOSTIC SYSTEM PID/DATA MONITOR INSPECTION .) LPS Is the LPS PID value normal?	Yes	Overhaul the control valve body and repair or replace any malfunctioning parts. (See AUTOMATIC TRANSAXLE - [FS5A-EL] -- MAZDA6 ) If any problem remains, overhaul the transaxle and repair or replace any malfunctioning parts. (See AUTOMATIC TRANSAXLE - [FS5A-EL] -- MAZDA6 )
3		No	Repair or replace any malfunctioning parts.
4	Verify the test results. If normal, return to the diagnostic index to service any additional symptoms. If the malfunction remains, inspect the related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis. If the vehicle is repaired, troubleshooting is completed. If the vehicle is not repaired or additional diagnostic information is not available, replace the TCM.