No. 1 Vehicle Does Not Move In D, M Or In R Position: Notes
WARNING: This page is about a different variant/trim than selected.
DESCRIPTION AND POSSIBLE CAUSE
| 1 |
Vehicle does not move in D, M or in R position |
| DESCRIPTION |
- Vehicle does not move when the accelerator pedal is depressed.
|
| POSSIBLE CAUSE |
- If the vehicle does not move in D, M or R position, basically, the malfunction is in the ATX. (Vehicle will move even with a malfunction in the TCM.) Since a malfunction is in the sensor circuit or output circuit is the cause of the malfunction in the ATX, inspect the sensors, output circuit, and the related wiring harnesses.
- Clutch slippage, worn (D, M positions-Forward clutch, R position-Reverse clutch, Low and reverse brake, Reduction brake)
- Line pressure low
- Shift solenoid D malfunction
- Shift solenoid A malfunction
- Shift solenoid B malfunction
- Pressure control solenoid A malfunction
- Pressure control solenoid B malfunction
- Body GND malfunction
- Control valve body malfunction
- Selector lever malfunction
- Improper operation of parking mechanism
- Torque converter malfunction
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted.
|