LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Starting System [MZR 2.5]) >> Starter Interlock Switch Inspection

Starter Interlock Switch Inspection

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Do not reuse the starter interlock switch if it is removed from the vehicle even once. Replace with a new starter interlock switch when installing.
  1. Disconnect the negative battery cable.
  2. Disconnect the starter interlock switch connector.
  3. Verify that the continuity is as indicated in the table using a tester.
    Fig 1: Starter Interlock Switch Terminals Continuity Chart
    G07620692Courtesy of MAZDA MOTORS CORP.
    Fig 2: Starter Interlock Switch Terminals
    G07620693Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals