TR Switch Installation Note

WARNING: This page is about a different variant/trim than selected.

Verify that the manual shaft is aligned with N position.

Fig 1: Aligning Manual Shaft
Courtesy of MAZDA MOTORS CORP.
Adjust the TR switch between terminals B and C until the resistance becomes 713-787 ohms .
Tighten the TR switch installation bolts.
Tightening torque 8-11 N.m {82-112 kgf.cm, 71-97 in.lbf}

Fig 2: TR Switch Connector Terminals
Courtesy of MAZDA MOTORS CORP.