Manual Shaft Nut Installation Note
WARNING: This page is about a different variant/trim than selected.
- Set the adjustable wrench as shown to hold the manual shaft lever and tighten the manual shaft nut.CAUTION:
- Do not use an impact wrench. Hold the manual shaft lever when installing the manual shaft nut, or the transaxle may be damaged
- Do not apply torque to the manual shaft as bending or breakage of the spring pin installed to the manual shaft could damage the TR switch and cause a selector lever malfunction.
Tightening torque 32-46 N.m {3.3-4.6 kgf.m, 24-33 ft.lbf}