On-Vehicle Inspection: Notes

WARNING: This page is about a different variant/trim than selected.

Engage the parking brake and use wheel chocks at the front and rear of the wheels.
Disconnect the TR switch connector.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
3. Disconnect the TR switch connector.
  
  Fig 1: TR Switch
  Courtesy of MAZDA MOTORS CORP.
Inspect continuity as indicated in the table.
- If there is any malfunction, adjust the TR switch. (See TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT .)
- If a malfunction occurs after performing adjustments, replace the TR switch. (See TRANSAXLE RANGE (TR) SWITCH REMOVAL/INSTALLATION .)
  
  Fig 2: TR Switch Connector Terminals
  Courtesy of MAZDA MOTORS CORP.