On-Vehicle Inspection: Notes

WARNING: This page is about a different variant/trim than selected.

Disconnect the coupler component connector.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
3. Disconnect the coupler component connector.
  
  Fig 1: Coupler Component
  Courtesy of MAZDA MOTORS CORP.
Measure the resistance between the coupler component terminal E and H.
- If there is any malfunction, replace the coupler component. (See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION .)
  
  Fig 2: Coupler Component Connector Terminals
  Courtesy of MAZDA MOTORS CORP.