LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Automatic Transaxle (Service, Removal & Installation FS5A-El)) >> Solenoid Valve Inspection >> Secondary Control Valve Body >> On-vehicle inspection

On-vehicle inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the coupler component connector.
    1. Disconnect the negative battery cable.
    2. Remove the battery. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
    3. Remove the battery tray. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
    4. Disconnect the coupler component connector.
      Fig 1: Coupler Component
      G07625892Courtesy of MAZDA MOTORS CORP.
  2. Measure the resistance between the coupler component terminals A and B.
    • If there is any malfunction, inspect the coupler component for continuity.
    • If coupler component has no malfunction, perform the "Off-vehicle inspection". (See OFF-VEHICLE INSPECTION .)
scientia non olet · About LEMON Manuals