Off-Vehicle inspection

WARNING: This page is about a different variant/trim than selected.

Measure the resistance between the coupler component terminals.
- If there is any malfunction, replace the solenoid valve.
Pressure control solneoid A specification 2.4-7.3 ohms

Fig 1: Pressure Control Solneoid A Connector Terminals
Courtesy of MAZDA MOTORS CORP.

Shift solneoid A, B, C specification 1.0-4.2 ohms

Fig 2: Shift Solneoid A, B And C Connector Terminals
Courtesy of MAZDA MOTORS CORP.

Shift solneoid D, E specification 10.9-26.2 ohms

Fig 3: Shift Solneoid D And E Connector Terminals
Courtesy of MAZDA MOTORS CORP.