Oil Pressure Switch Removal/Installation

WARNING: This page is about a different variant/trim than selected.

WARNING:

A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool.

CAUTION:

Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

Disconnect the negative battery cable.
Remove the aerodynamic under cover NO. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .)
Remove in the order indicated in the table.

Install in the reverse order of removal.

PARTS DESCRIPTION CHART

Fig 1: Oil Pressure Switch, Connector And Washer With Torque Specification

Courtesy of MAZDA MOTORS CORP.