LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Automatic Transaxle (Service, Removal & Installation FS5A-El)) >> Oil Pressure Switch Inspection >> Off-Vehicle Inspection >> Notes

Off-Vehicle Inspection: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Apply air pressure at 400-440 kPa {4.08-4.48 kgf/cm 2  , 58.1-63.8 psi}  as shown in the illustration.
    Fig 1: Checking Air Pressure
    G07625867Courtesy of MAZDA MOTORS CORP.
  2. Inspect continuity between the oil pressure switch terminals A and screw part.
    • If there is any malfunction, replace the oil pressure switch.
      Fig 2: Oil Pressure Switch Connector Terminals
      G07625868Courtesy of MAZDA MOTORS CORP.