LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Automatic Transaxle (Service, Removal & Installation FS5A-El)) >> Oil Cooler Removal/Installation >> Oil Hose Installation Note >> Radiator side

Radiator side

WARNING: This page is about a different variant/trim than selected.
  1. Install the oil hose to the position shown in the illustration.
    • Verify that the installation angle of the oil hose is within the range shown in the illustration.
      Fig 1: Oil Hose Installation Position (Radiator Side)
      G07625934Courtesy of MAZDA MOTORS CORP.
  2. Install the hose clamp to the position shown in the illustration.
    • Verify that the hose clamp is within the marked area of the oil hose.
    • Verify that the installation angle of the hose clamp is within the range shown in the illustration.
      NOTE:
      • If the oil hose is to be re-used, install the hose clamp to the impression in the hose left by the previous installation. After installation, apply force to the hose clamp in the direction of the arrows to engage the hose clamp securely.
        Fig 2: Hose Clamp Installation Position (Radiator Side)
        G07625935Courtesy of MAZDA MOTORS CORP.
  3. Verify that the hose clamp does not interfere with surrounding the accessories.
    Fig 3: Locating Hose Clamp (Radiator Side)
    G07625936Courtesy of MAZDA MOTORS CORP.


  1. Install the oil hose to the position shown in the illustration.
    • Verify that the installation angle of the oil hose is within the range shown in the illustration.
      Fig 1: Oil Hose Installation Position (Radiator Side)
      G07625947Courtesy of MAZDA MOTORS CORP.
  2. Install the hose clamp to the position shown in the illustration.
    • Verify that the hose clamp is within the marked area of the oil hose.
    • Verify that the installation angle of the hose clamp is within the range shown in the illustration.
      Fig 2: Hose Clamp Installation Position (Radiator Side)
      G07625948Courtesy of MAZDA MOTORS CORP.
      NOTE:
      • If the oil hose is to be re-used, install the hose clamp to the impression in the hose left by the previous installation. After installation, apply force to the hose clamp in the direction of the arrows to engage the hose clamp securely.
  3. Verify that the hose clamp does not interfere with surrounding the accessories.
    Fig 3: Locating Hose Clamp (Radiator Side)
    G07625949Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals