Line Pressure
WARNING: This page is about a different variant/trim than selected.
LINE PRESSURE SPECIFICATION CAHRT
| Test Condition | Specification (kPa {kgf/cm2 , psi}) | |
|---|---|---|
| Idle | R position | 490-710 {5.00-7.23, 71.1-102.0} |
| D, M (1GR, 2GR) positions | 330-470 {3.37-4.79, 47.9-68.1} | |
| Stall | R position | 1,850-2,120 {18.87-21.61, 268.4-307.4} |
| D, M (1GR, 2GR) positions | 1,200-1,320 {12.24-13.46, 174.1-191.4} | |
- 8. Stop the engine.
- 9. Remove the SSTs.WARNING:
- Removing the SSTs when the ATF is hot earn he dangerous. Hot ATF can come out of the opening and badly burn you. Before removing the SSTs, allow the ATF to cool.
- 10. Install a new square-head plug in the inspection port.NOTE:
- Do not reuse the square-head plug because it is coated.
Tightening torque 4.8-9.8 N.m {49-99 kgf.cm, 43-86 in.lbf}
- 11. Install the aerodynamic under cover NO. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION .)