LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Automatic Transaxle (Service, Removal & Installation FS5A-El)) >> Input/Turbine Speed Sensor Removal/Installation

Input/Turbine Speed Sensor Removal/Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Always use a new bolt. If the removed input/turbine speed sensor installation bolt is reused, it may cause oil leakage.
  • A sealant coating is applied to the input/turbine speed sensor installation bolt to prevent oil leakage from the installation bolt hole which passes through the component.
  • If foreign materials are stuck to tire sensor, disturbance by magnetic flux can cause sensor output to be abnormal and thereby negatively affect control. Make sure that foreign materials such as iron filings are not stuck to the sensor during installation.
  • Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.
  1. Disconnect the negative battery cable.
  2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  3. Remove in the order indicated in the table.
  4. Install in the reverse order of removal.
    PARTS DESCRIPTION CHART

    1 Connector
    2 Input/turbine speed sensor
    3 O-ring
    Fig 1: Input/Turbine Speed Sensor, Connector And O-Ring With Torque Specification
    G07625873Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals