Transaxle Installation Note
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Verify that the torque converter stud bolts are inserted into the drive plate bolt holes, and install the transaxle installation bolts. Otherwise, the drive plate could be damaged.
- Verify that the torque converter stud bolts are inserted into the drive plate bolt holes from the starter installation hole.
- Tighten the transaxle mounting bolts.
Tightening torque 38-52 N.m {3.9-5.3 kgf.m, 29-38 ft.lbf}