No. 4 Engine Mount Installation Note

WARNING: This page is about a different variant/trim than selected.

Tighten nuts on the No. 4 engine mount bracket in the order of A to C.
Tightening torque 67-93 N.m {6.9-9.4 kgf.m, 50-68 ft.lbf}

Fig 1: No. 4 Engine Mount Bracket Nuts Tightening Sequence
Courtesy of MAZDA MOTORS CORP.
Tighten the new bolts on the No. 4 engine mount rubber.
Tightening torque 77-103 N.m {7.9-10 kgf.m, 57-75 ft.lbf}

Fig 2: No. 4 Engine Mount Rubber Bolts
Courtesy of MAZDA MOTORS CORP.