Snapshot data table
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Refer to PID monitor table for confirm the transaxle control system operation status while the TCM does not store the DTC. (See ON-BOARD DIAGNOSTIC SYSTEM PID/DATA MONITOR INSPECTION .)
- Snapshot data items are not displayed, according to detected DTC.
SNAPSHOT DATA CHART
| Snapshot data item | Unit | Definition | Corresponding PID data monitor item |
|---|---|---|---|
| LOAD | % | Calculated engine load | - |
| ECT | °C {°F} | Engine coolant temperature | ECT |
| RPM | RPM | Engine speed | RPM |
| VSS | KPH {MPH} | Vehicle speed | VSS |
| SPARKADV | 0 | Ignition timing | - |
| IAT | °C {°F} | Intake air temperature | - |
| TP1 | % | Throttle valve position No. 1 | - |
| EG_RUN_TIME | - | Time from engine start | - |
| CLR_CNT | - | Number of warm-up cycle after DTC cleared | - |
| CLR_DIST | Km {mile} | Mileage after DTC cleared | - |
| VPWR | V | Module supply voltage | VPWR |
| APP1 | % | Accelerator pedal position No. 1 | - |