Reading DTCs Procedure: Notes
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS (IDS) to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- Select "Self Test".
- Select "Modules".
- Select "TCM".
NOTE:- Snapshot data appears at the top of the help screen when the displayed DTC is selected.
Snapshot data
- The snap shot data stores the currently detected DTC data.
- The recording timing for the freeze frame data/snap shot data differs depending on the number of DTC drive cycles.
- For a DTC with a drive cycle number 1, only the malfunction determination data is recorded.
- For a DTC with a drive cycle number 2, both the malfunction determination and undetermined data is recorded.
- Verify the DTC according to the directions on the M-MDS screen.