DTC P2708:00: Notes
WARNING: This page is about a different variant/trim than selected.
DTC DESCRIPTION CHART
| DTC P2708:00 |
Shift solenoid F stuck on |
| DETECTION CONDITION |
- The TCM detects that revolution ratio of the intermediate revolution to output revolution is 1.11 or more for 5 s when the following conditions are met.
- 5GR
- Accelerator pedal position: 4.67% or more
Diagnostic support note
- The MIL illuminates U the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle white the DTC for the same malfunction has been stored in the TCM.
- The AT warning Sight illuminates.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level tow
- Shift solenoid F stuck off
- Line pressure malfunction
- Secondary control valve body malfunction
- TCM malfunction
|