DTC P2707:00: Notes
WARNING: This page is about a different variant/trim than selected.
DIAGNOSTIC PROCEDURE CHART
| DTC P2707:00 |
Shift solenoid F stuck off |
| DETECTION CONDITION |
- The TCM detects that revolution ratio of the intermediate revolution to output revolution is 1.11 or less for 5 s when the following conditions are met.
- 3GR or 4GR
- Accelerator pedal position: 4.67% or more
Diagnostic support note
- The MIL illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM.
- The AT warning light illuminates.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Shift solenoid F stuck off
- Line pressure malfunction
- Secondary control valve body malfunction
- TCM malfunction
|