DTC P0882:00: Notes
WARNING: This page is about a different variant/trim than selected.
DTC DESCRIPTION CHART
| DTC P0882:00 |
Battery back-up voltage low |
| DETECTION CONDITION |
- The TCM detects that battery back-up voltage is 2.5 V or less for 2 s.
Diagnostic support note
- The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- The AT warning light does not illuminate.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- The DTC is stored in the TCM memory.
|
| POSSIBLE CAUSE |
- Melt down ENG +B 10A fuse
- ENG +B 10A fuse connector or terminal malfunction
- Battery positive terminal malfunction
- Battery malfunction
- Short to GND in wiring harness between battery positive terminal and TCM terminal 1K
- TCM connector or terminal malfunction
- Open circuit in wiring harness between battery positive terminal and TCM terminal 1K
- TCM malfunction
|
|
|